Search results

BD30 (3.0l) DI Full mechanical injection direct injection diesel (NO glow plugs) and NO emission control garbage with a LONG stroke, great torque potential. These engines factory will make 200hp + with just exhaust cut off and boost/fuel wound up on standard turbo. This set up has the potential...

As stated above, front of gearbox/ bell housing and inlet manifold assembly Can pick up between Brisbane and tamworth has to be good condition Need these ASAP Make an offer on price cheers Matt

Hey guys Has anyone measured the compressed eye to eye measurement when the stock rear leaf is bottomed out against the bump stops??? Looking at putting 10 inch 5125 bilstein shocks with a near 400mm closed and 658 open wondering if i can squeeze them without hitting destroying the shocks or...

Hey guys As stated above 4x 33x10.5 km2, on 15x7 +10 offset black with yellow/red pin stripe sunraysia's Approximately 80%, 10-15k old Rotated once, well balanced. No punctures Located Brisbane Prefer pickup as postage would be huge. 800 for the lot

Prefer it to be stripped/blown but will consider working units. Can pick up near Brisbane or close to wollongong Make an offer cheers Matt

Alright im strting to get bored with the 4.625 ratio and 33. Since it can be done, im looking at swapping to 35 at come point. i dont want my fuel economy to suffer so i would like to switch to 4.88 ratio. 100km/hr= 99-101 (est) GPS km/hr with 4.88 so still relatively stock- around 2750 rpm at...

Theres plenty of threads out there on k&n filters, however none have really answered my query, possibly because they have enough dignity not to ask :/ :D anyway here it is, I know k&N on a diesel do diggley squat to power, but do they increase induction noise? I know its purely a Wank factor...

Hey guys Have noticed when my car is at temperature or on a decent 20-30 minute drive its hard to get into gear when stopped/stationary in traffic, the occasional stop its fine just prolonged stop start crawling. Changing gear when driving is perfect, same as always, never crunches. It also...

Hey guys just swapped my rear diff in my 2003 d22 with a h233b 4.6 ratio. also put another tail shaft in from a 1997 navara which is required. however now im getting a very Vilolent shake/vibration when underload. most noticable whem i take off hard in 1st 2nd or under heavy load in low revs...

Hey Guys Went diff crazy latley and have bought to many diffs for the d22 zd30 as im doing a ration swap. So i have a 1997 d22 H233B (patrol diff) 4.625 ratio diff= 31 spline drum to drum. Unit has been ground back to bear metal and undercoated, drums have been ground back and a film of rust...

Hey guys I've got new diffs coming from Queensland, a h233b and r180 out of a D22 QD32, however the rear diff is supposedly open (I will not receive diffs until at least 2 weeks so I am unable to check). It's definitely out of a D22 as the track width is the same as my 2003 D22 Nav. Now being...

Ive been through few chips for the zd30. All i can say is that they vary a lot, from modulation to fuel delivery (spill/fuel pressure sensor) What chips offer the wildest fuel settings?? as i have found i cant seem to find a chip that deliever nice fuel progression and alot of fuel potential...

Hey Guys since putting 33 on standard 4.375 gearing... the car it a little labored, i was wondering if it possible to swap both front a rear 4.625 ring/pinion from the Qd32 (R180, H233b) into the zd30 d22 diffs (r180 and c200) would this be a hassle free swap, well the front should be, however...

Hey guys This chip always did this when installed. The chip only actives around 50% throttle depth, so no modulation its like a light. Switch. rang chipit a while ago and asked for a resolution, I had it installed directly to the ecu and they said try the tps which had no difference. So has...

Hey guys 2003- d22 zd30 ive developed a large vibration under load when i labor the car in a high gear with heavy throttle.... only noticeable when the chip is activated as the extra torque triggers it. I feel it as though its through the rear cab wall and floor under the seat... I have a 3...

Just discovered when i'm under the car turning the front drive shaft, you can hear a Click click click every few revolutions. So i suspect that the noise (Clunk) im hearing after a good 4x4 trip is a front diff, in particular the Ring gear. so is there anywhere cheap i can grab a ring gear...

hey guys just got back from yalwal and ive noticed the noise i heard at fraser island earlier this year got a lot louder. it only occurs when the hubs are locked in, either in 2wd and locked or 4 and locked. The noise is a.... vroom vroom vvroom vroom noise, occurs on both sides i believe it...

Hey guys having a small boost issue i think... It happens right around 2700-2800 the sound is a loud hissing noise, much like the noise i think the butterfly makes at a certain RPM. It never used to do this, I could pull past 3 thousand without this noise occurring. I have pressure tested...

what lift am i running Hey guys Ive always just counted the rear of my ute as a 2inch lift However ive never been 100% as i bought the car this way. The rear has helper coils, unsure of the make and what looks to be a 4 pack of leafs. The reason being is that ive just order new rancho rs9000xl...

Hey Guys While the car is clean i thought i would throw up some pics of the nav. bought it in WA and got it couried over to NSW. It was just a bare Nav, added Most things that are obviously aftermarket Everything you see is custom made and a garage job. Car: 2003 ZD30 with 125,000k Exterior...